5. Several predefined
Basic Configurations
have been included for the DSP-100 (see
Figure 5. DSP-100 Basic Configuration Table). The Basic Configurations provide
many combinations of the operating modes and options listed below. See the
Hardware Information
section of this manual for complete descriptions.
When the
Use Automatic Settings
check box is enabled Windows 95/98/ME will
attempt to configure the DSP-100 in the order listed in the Basic Configurations table.
Scratch Pad
8x
Any
0003
Scratch Pad
Normal
Any
0002
ISR
8x
Any
0001
ISR
Normal
Any
0000
Scratch Pad/
ISR
Clock
Speed
I/O Range***
Basic
Configuration
*** Any indicates variable value; this value may or may not be user selectable depending on platform.
6. Select a
Basic Configurations
that displays "No conflicts" in the bottom display
region titled
Conflicting Device List
from the drop down list.
7. To modify the
Interrupt Request
setting click the resource name and click the
Change Setting
button. An Edit Resource window will open up. Inside this window
click on the up/down arrows to the right of the Interrupt Request value. This scrolls
you through all of the allowable resources for your hardware. Pay attention to the
conflict information at the bottom of the window. Do not select a value that causes a
conflict with any other installed hardware.
8. If any changes have been made to the DSP-100’s configuration the card will
automatically be reconfigured to the new resources specified. Any time a PCMCIA
card of this type is inserted Windows 95/98/ME will attempt to configure the card at
these resource settings. Click the
Use Automatic Settings
box to reset this card type
for automatic configuration.
3.3 Frequently Asked Questions
Basic Configuration List Not Available:
A problem noted on some systems is after a basic configuration has been manually selected the
basic configurations list for the DSP-100 is no longer available. The solution to this problem is
to check the “Use Automatic Settings” box and allow Windows 95/98/ME to reconfigure the
DSP-100 card. The basic configurations list should once again be visible.
Windows 95/98/Millennium (ME)
3-3
Содержание DSP-100
