3.)
Push [F1] to start the storage of the sequence. The display shows:
Name: xxxxxxxx
[ok[ [cancel]
4.)
Now you can give a name to your sequence. With [PAGE<>] you can select the character
position and with <VALUE> select the corresponding characters/special symbols. The
name can also be entered in over a connected MIDI keyboard. Look in the appendix for
the character table.
5.)
If you are pleased with the name, push [F1] again. If you want to leave the menu without
storing, push [F2] then [EXIT]. In the first case the following message is in the display:
To xx (xxxxxxxx)
[ok] [cancel]
6.)
With <VALUE> you can select the target memory, which will be overwritten with the
new sequence. The name of the designated sequence will be shown on the display.
7.)
With [F1] the storage will take place, with [F2] you can still cancel storing.
8.)
With [EXIT] you can leave the write menu.
Initializing the complete Memory/
reloading of the factory settings
If you would like to go back to the original factory settings, you can completely initialize the
POLYMORPH. When replacing the battery or after an update an initialization has to be made.
CAUTION!!
When initializing you lose all of your saved data.
To initialize turn the POLYMORPH off and follow the next steps:
1.)
Push [WRITE] and hold the button.
2.)
Holding the button turn the POLYMORPH on.
3.)
The following message will be shown in a few seconds.
Initialize All?
[ok] [cancel]
4.)
Now you can release [WRITE].
5.)
Push [F1] for the initialization. With [F2] you can abort the process.
In general to initializing single memory areas
On the following pages of the write menu you can set single memory areas into a basic condition.
For an example, when you initialize a sound, you get a very simple basic sound with an opened
filter and neutral envelope setting. The initialized sound has no modulations and is devoid of every
effect action.
Initializing procedures have one thing in common. They always refer to the temporary memory.
When initializing stored data is not lost (except with a complete initialization). If you want to delete
a sound, setup or whatever, you have to save the initialized sound, initialized setup or initialized
sequence. A basic, initialized memory area is not available.
50
The write menu
!
