Quark-Elec QK-G022, Руководство пользователя

Страница: 8 / 31

Quark-elec Manual
https://www.quark-elec.com 8 of 31 2018
V2
6. Configuration
The following steps are required to configure G021/22 for first time use:
 Insert the SIM card into controller box
 Power up

Send ‘
888888
’ as SMS to the G021/22 controller. If successful, the user will receive the message ‘
Your
phone has been registered’ . This command should be received within the first 600 seconds after powering
up G021/22. Otherwise “registered Disabled” message will be sent back to inform the failure of the main SIM
registration . If this happens, turn off the device and start again.
 If additional mobile terminals are required, the operator should send “ BDn (mobile terminal number) F ” to the
G021/22 controller. The user will receive the message “ Your phone has been registered ”. Up to 3 additional
terminals can be configured (the main mobile number registered with the device won’t show up when “ WHORED ” is
sent).The operator is now ready to use G021/22. Details about the SMS command and response messages can be
found in chapter 10
You can control the device by either:
 Manually entering the codes by SMS text message
 Using the phone APP (android and iOS) interface. Using the APP, you simply select the action you want and
the APP formulates and sends the SMS message for you. This App does not allow you to send messages to
your device for free nor does it work over WiFi.
7. Status LED’s
The device has two working LED’s to notify the user of its current operations. The network LED and the system LED.
Both these LED’s flash depending on their operating status.
 Network LED – LED will flash blue at start up as it looks for a network signal. Once a signal has been found
the LED will flash much slower, every 3 seconds.
 System LED - will flash at 1 second intervals once the system has finished initialization. It will then flash
every time it is operating a command