Chapter 2 Installation and Quick Start
Installing an Internal LTO-2 Half-Height Tape Drive
14
LTO-2 Half-Height Tape Drive User’s Guide
Checking the SCSI
Termination
2
By default, the internal LTO-2 Half-Height Tape Drive does not provide
SCSI termination. If you use this default setting, you must place a SCSI
bus terminator or a SCSI device with termination enabled at the end of
the SCSI chain. See
figure 6
for two examples of SCSI termination.
The internal LTO-2 Half-Height Tape Drive provides terminator power if
a jumper is placed on the termination power jumper pins (see
Terminator
Power
on page 10).
Figure 6 Two SCSI
Termination Examples
for the Internal LTO-2
Half-Height Tape Drive
Connecting a
Serial Cable for
Tape Libraries
2
The Internal LTO-2 Half-Height Tape Drive include an RS-422 serial
interface for tape libraries. The LTO-2 library interface uses an in-line
shrouded and keyed 10-pin connector. This connector is located on the
lower left side of the back of the drive (see
figure 5
).
Table 2
shows pin
assignments.
CSI Controller
mination enabled)
Tape drive
SCSI device
SCSI device
(termination
enabled)
(termination
disabled)
(no
termination)
SCSI Terminator
SCSI Controlle
(termination enab
Tape drive
(no
termination)
Содержание ValueLoader LTO-2
