Quantum SPARK 1575, Руководство по началу работы, Страница: 41 / 90

Using the First Time Configuration Wizard
Quantum Spark 1575 / 1595 Appliance Getting Started Guide | 41
Zero Touch
Zero Touch enables a gateway to automatically fetch settings from the cloud when it is
connected to the internet for the first time.
Note - You cannot use Zero Touch if you connect to the internet with a proxy server.
If the gateway connects to the internet through DHCP, the gateway will fetch the Zero Touch
settings without any additional action. If no DHCP service is available, you must run the First
Time Configuration Wizard, configure the Internet Connection settings, and then fetch the
settings from the Zero Touch server.
To connect to the Zero Touch server:
1. In the Welcome page, click Fetch Settings from the cloud.
2. In the window that opens, click OK to confirm that you want to proceed.
3. The Internet connection page opens. Configure your Internet connection and click
Connect.
4. The Fetching settings from the cloud window opens and shows the Connecting to the
service provider status. This process may take several minutes.
5. If you fail to connect, an error message appears. Possible errors include:
n
Internet connection is not configured correctly.
n
Internet connection is through a proxy server.
n
Zero Touch is already running.
n
Zero Touch service already completed.
n
The First Time Configuration Wizard already completed.
n
Zero Touch service is disabled.
Where applicable, click Retry now to connect again.
6. After you connect to the server, the settings are automatically downloaded and installed.
The status is shown in the Fetching settings from the cloud window. It may take several
minutes until the installation is complete.
7. Click Finish.
Note - If a collision is detected between an internal network (LAN) and an IP returned
using DHCP (WAN), the conflicting LAN address is changed automatically. If a
colliding LAN IP address is changed, a message appears in the system logs.
When you reconnect to the WebUI or click Refresh, the browser opens to show the status of
the installation process.