Quantum QXS G2 Series, Руководство по установке и обслуживанию оборудования

Страница: 77 / 246

Installation 65
• Front: Callout 4 (screw B)
• Rear: Callout 8 (screw B)
5 Tighten the middle slide locking screws (callout 11).
6 Ensure the rear spacer clips (x4) are fitted to the edge of the rack post.
7 Slide the chassis fully home on its rails.
8 Fasten the front of the chassis using the chassis fastening screws (callout 3, screw A, x4) as shown
in Figure 61 .
9 Fix the rear of the chassis to the sliding bracket with the rear chassis fastening screws (callout 9,
screw C).
CAUTION: Use only power cords supplied, or power cords that comply with the specifications in AC
Power Cords on page 223.
CAUTION: Once the chassis is installed in the rack, dispose of the lifting straps.
Due to the difficulty in attaching the straps once the chassis is installed into the rack, the straps are
not suitable for removing the chassis from the rack.
10 Reinsert all of the rear panel CRUs, and install all of the DDICs into the drawers accessed from the
front panel per the following instructions:
• Install five fans
Installing a 5U84 System Fan on page 206
• Install two PSUs Installing a 5U84 System PSU on page 204
• Installing two RAID controllers or expansion IOMs Installing a 5U84 RAID Controller or
Expansion IOM on page 210
• Install all DDIC Installing a 5U84 DDIC on page 194
• See also:
• Accessing 5U84 Drawers on page 191
• Populating 5U84 Drawers on page 195
11 If you removed the cabinet doors, install them now.
Full Disk Encryption (FDE)
The Full Disk Encryption (FDE) feature available via the management interfaces requires use of
self-encrypting drives (SED) which are also referred to as FDE-capable drive modules. When installing
FDE-capable drive modules, follow the same procedures for installing drives that do not support FDE.
The procedures for using the FDE feature, such as securing the system, viewing drive FDE status, and
clearing and importing keys are performed using the disk management utility (GUI) or CLI commands.