Quantum PX720, Руководство пользователя

Страница: 57 / 259

Chapter 1 Library Description
Getting Started
Quantum PX720 User’s Guide 34
4 Route an Ethernet cable up through the base of the library and
connect the front Ethernet port located on the right side of the cabinet
controller to the local network (see figure 19 ).
Figure 19 Connecting the
Library to the Local Area
Network
5
Close the back door.
Loading the Tape
Cartridges
1
Before operating the library, load the appropriate tape cartridges (LTO or
SDLT) into the library starting with the left-hand panels (see Shelf Slot
Numbering Conventions on page 8 for slot locations).
Initial Configuration
1
The Quantum PX720 must be initially configured with an IP address
before the remote management software is available.
To configure the Quantum PX720 IP address:
1 Press on the top of the service tray to tip it down and press the power
button to turn on the library (see figure 20 ).
Local area
Ethernet port
Cabinet controller enclosure
shown outside for clarity
Internal network
Service port