Quantum DX-Series: Optional X520 Network Card Installation Instructions
6-67765-01 Rev C
March 2014
4
Opening the Node Cover
2
Select
Shutdown
and click
Apply
.
3
Close the browser window.
4
After the Node shuts down, turn off both power switches on the back of
each Array or Expansion module (if any).
Note:
For detailed information about shutting down Array or Expansion
modules, see the
User’s Guide
for your DXi system.
Opening the Node Cover
To remove the DXi Node from the rack and remove the top cover:
WARNING:
Opening or removing the system cover when the system is on
may expose you to a risk of electric shock.
Caution:
Use appropriate ESD precautions, including the use of a grounding
strap, when working inside the Node.
1
If installed, remove the front bezel by lifting the latch on the left side of the
bezel.
2
Disconnect all power, SAS, Ethernet, and Fibre Channel cables from the rear
of the Node. Make sure to label the cables so they can be easily identified
when they are re-connected to the Node after the upgrade procedure is
complete.
3
Press the locking tab on either side of the Node, and pull the Node out from
the rack until the inner rails lock.
Note:
If necessary, remove the optional screws securing the Node to the
front of the rack (behind the locking tab).
4
Locate the lock levers on the sides of the inner rails (see
Figure 4
). Unlock
each lever by rotating it up to its release position.
