Prism FC420 Bridge Option User’s Guide
Document 6473031-04, Ver. 4, Rel. 0
September 2003
Prism FC420 Services Software Commands
23
RouteChange
(Immediate)
Map a Fibre Channel port (
fp
) and LUN
(
fl
) to a SCSI bus (
sb
), target (
st
), and LUN
(
sl
). Valid route change entries are:
fp
(0)
fl
(0-31)
sb
(0-1)
st
(0-15)
sl
(0-7)
routechange [fp] [fl] [sb] [st] [sl]
RouteDisplay
List the currently mapped Fibre
Channel-to-SCSI routes.
routedisplay
routedisplay [fp]
routedisplay [online | offline]
routedisplay [fp [fl]]
routedisplay [fp [online | offline]]
RouteOffline
Set the status of a route to offline.
set routeoffline [fp] [fl]
get routeoffline [fp] [fl]
RouteOnline
Set the status of a route to online.
set routeonline [fp] [fl]
get routeonline [fp] [fl]
SaveConfiguration
(Immediate)
Save the new configuration. If a
firmware restart is required to make the
change, the user is prompted to confirm
the restart. The user can override the
confirmation request by indicating the
override value on the command line.
saveconfiguration < restart |
nonrestart >
ScsiInitID
Specify the SCSI initiator ID to be used
on the specified SCSI port.
0x07
set scsiinitid [sb [0-15]]
get scsiinitid [sb]
ScsiPortBusSpeed
Specifies the transfer rate at which the
FC420 bridge will attempt to negotiate
with SCSI devices. The choices are Fast
SCSI, Ultra SCSI, Ultra 2 SCSI, and Ultra
3 SCSI.
ultra3
set scsiportbusspeed
[portnumber [fast | ultra | ultra 2
| ultra3]]
get scsiportbusspeed
[portnumber]
ScsiPortList
(Immediate)
List the available SCSI ports and their
status.
scsiportlist
ScsiPortReset
(Immediate)
Resets the specified SCSI bus.
scsiportreset [sb]
ScsiPortResetOnStartup
Specify whether the SCSI port should be
reset on power-up.
enabled
set scsiportresetonstartup [sb
[enabled | disabled]]
get scsiportresetonstartup [sb]
Command
Description
Default
Syntax
