Quantum FC420, Руководство пользователя

Страница: 21 / 30

Prism FC420 Bridge Option User’s Guide
Document 6473031-04, Ver. 4, Rel. 0
September 2003
Prism FC420 Services Software Commands 21
IPDHCP
Enables/disables the capability of the
FC420 bridge to request an IP address
from a DHCP server on the network.
enabled set ipdhcp [enabled | disabled]
get ipdhcp
IPGateway
Sets/displays the current default
gateway. If the
ipdhcp
command is
enabled, the
get
command reports the
current IP gateway assigned by the
nameserver.
0.0.0.0 set ipgateway xxx.xxx.xxx.xxx
get ipgateway
IPSubnetMask
Sets/displays the current subnet mask.
If the
ipdhcp
command is enabled, the
get
command reports the current IP subnet
mask assigned by the nameserver.
255.255.
255.0
set ipsubnetmask
xxx.xxx.xxx.xxx
get ipsubnetmask
IsReserved
(Immediate)
Displays the reservation status of the
current FC420 bridge services session/
interface. When a reserve flag is set, the
configuration image is undergoing
modification by another FC420 bridge
services session.
Set
commands are
unavailable while in this state.
Get
commands are available, however.
Executing a
saveconfiguration
,
restoreconfiguration
, or
firmwarerestart
command releases the reserved state so
that other users may issue set
commands.
isreserved
LogEvent
Sets the switches which control the
filtering performed when logging
events.
set logevent [enabled |
disabled] | [[subsystem]
[event_level] [status]]
get logevent
The switches have the following meanings and settings:
[enabled | disabled]
switch: controls whether or not events logging is
enabled or disabled.
disabled
[subsystem]
switch: same as switch for
DispEvent
(see DispEvent on
page 17)
3Fh
[event_level]
switch: same as switch for
DispEvent
(see DispEvent on
page 17)
3Fh
[status]
switch: same as switch for
DispEvent
(see DispEvent on page 17)
all
MaxEnclTempAlrm
Sets/displays the maximum enclosure
temperature alarm of the unit in degrees
C (0-70 degrees C).
70°C set maxencltempalrm [0-70]
get maxencltempalrm
Menu
Enables/disables the menu interface.
Entering the command alone without
parameters toggles the current state.
menu <[enabled | disabled]>
Command Description Default Syntax