Quantum Europa, Руководство по эксплуатации

Страница: 12 / 20

12
System Status Light
The system status light is normally on when the system is powered up, and off when the system is
powered down. This light will flash if there is an internal fault, or if an OONAPU fault has occurred. See
“Out Of Neutral At Power Up.”
Magnetic Locking Area
Your power chair is equipped with a feature that enables you to “lock out” unauthorized users. For this
function, you will need the magnetic key supplied with your power chair. If you lose this key, contact your
Pride/Quantum Provider.
To enable the lockout system:
1. Hold the magnetic key on or near the key symbol. The system will beep and automatically turn off.
NOTE: None of the remote lights should be lit.
2. Press the on/off key to turn on the power chair. The key symbol will flash, but you will not be able to
drive your power chair. This means that it is still locked.
3. Hold the magnetic key on or near the key symbol again to unlock the system. When the key symbol
stops flashing, you may turn on the power chair.
NOTE: If you turn on the power chair while it is locked and do not unlock it after one minute, the
power chair will automatically turn off itself.
Battery Condition Meter
The battery condition meter consists of six lights arranged in an arc over the battery icon. From left to
right, the first two are red, the second two are orange, and the last two are green. These lights give
you an accurate indication of your usable battery capacity. If the battery has at least 85% of its rated
capacity, all of the lights will be on. As the battery voltage drops, the number of lights reduces from right
to left. When the battery capacity drops to 10% or below, all of the lights will flash once every second.
NOTE: When the battery capacity drops to below 21V (typically two lights), the controller will
reduce power chair performance to conserve battery power.
Drive Program Select Key
The drive program select key enables you to select a drive program and a power accessory mode. Your
Europa Controller was preprogrammed for five drive programs—1 (slowest) to 5 (fastest). The drive
mode is indicated by a number in the center of the keypad (drive mode and actuator display).
NOTE: The drive mode settings are preset at the factory. If your Pride/Quantum Provider changes
these settings, please make note of these changes.
To change the drive program:
1. Press the drive program select key until your desired drive program is displayed.
2. Use the joystick to operate your power chair.