page 4
LAMP AIMING
LIFE SAFETY SOLUTIONS
TEL: 800-705-SERV (7378)
Federal Communications Commission (FCC)
Requirements:
This device complies with FCC Title 47, Part 15, Subpart B.
this device does not cause harmful interference.
LAMP AIMING
1
To adjust the lamphead at
housing, twist lamphead to the
desired position. (Do not loosen
torque nut inside the housing.)
2
To adjust the lamphead around the
Aiming Screw
, loosen
Aiming
Screw
and aim lamphead to desired
position.
Aiming
Screw
Exploded View
CAUTION:
To aim, do not rotate the
lamphead without loosening the aiming
screw. Failure to do so will lead to
breakage of gasket of the Yoke mount.
Rotating lamphead on housing should
be done by swiveling head assembly.
(Do not loosen torque nut inside the
housing.)
3
Tighten the screw to finish aiming
procedure.
(Torque spec: 12 in-lbs)
Part # 912-00076-001
Rev. D, 06/2021
© 2020, Acuity Brands Lighting, Inc.
All Rights Reserved.
