Installing Expansion Modules
Quantum DXi4700 Capacity Upgrade Guide
38
kg). A minimum of two people are required to lift the chassis. To lift the chassis, use the slots in the
packing foam to place your hands under the sides of the chassis.
Caution:
Before proceeding, ensure that all hard drive latches are completely closed. Quantum
recommends that you do not remove the hard drives from the chassis. If they have been removed for
any reason during or after the installation, you must install the hard drives in the same position in which
they were removed.
1. Align the Expansion module with the rails, and then slide the module into the rack (see
).
2. Tighten the thumbscrews on each side of the Expansion module’s front panel.
Note:
To remove the Expansion module, loosen the thumbscrews and slide the Expansion
module out of the rack.
3. Install the end caps on either side of the module by inserting the top of the end cap first and then
snapping the bottom into place.
Install the end cap with the indicator icons to the left of the module, and install the end cap with the drive
numbers to the right of the module.
Note:
To remove the Expansion module, remove the screws and slide the module out of the rack.
Figure 29:
DXi4700 Expansion Module Installation
1
2
3
3
