![Quantum DXi2500-D Скачать руководство пользователя страница 144](http://html1.mh-extra.com/html/quantum/dxi2500-d/dxi2500-d_manual_3791090144.webp)
Quantum DXi-Series Command Line Interface (CLI) Guide
6-66538-03 Rev C
November 2010
144
Other System Configuration CLI Commands
E8004405 TestSnmptrap: Failed to write/set option "test".
E8004411 TestSnmptrap: Option "trapip" is missing.
E8004412 TestSnmptrap: Option "trapip" requires a value
E8004413 TestSnmptrap: Option "trapip" has invalid value
E8004414 TestSnmptrap: Failed to read/get option "trapip"
E8004415 TestSnmptrap: Failed to write/set option "trapip".
E8004421 TestSnmptrap failed!
E8004422 TestSnmptrap failed to validate trap destination address!
E8004423 Number of trap destinations cannot exceed 5
Utilities CLI Commands
The following utilities CLI commands are available:
•
Displaying Jumbo Frames Status
•
•
•
•
•
•
•
Setting the Reclamation Schedule
•
Displaying the Current Reclamation Schedule
•
Rebooting, Shutdown, or Reset Diagnostic
•
•
•
•
•
Displaying Jumbo Frames Status
syscli --getstatus jumbo [--dev <device> | --all ]
Note:
This CLI command is not available for DXi6700 systems.
This CLI command allows the CLI admin to display the current jumbo frames
status (enabled or disabled). Use the
--dev <device>
option to display jumbo
frames status for the specified device (for example, bond0, bond1, eth0). If you
do not specify a device, the status for bonded devices is displayed. Use the
--all
option to display jumbo frames status for all network devices.