QE7020
OPERATION
There may be a trace of smoke or odour during the first few minutes of initial use or when the unit has not
been used for a period of time. This is quite normal and will disappear quickly.
FROM THE FRONT PANEL
To switch on the appliance press the red rocker switch to the ON position. The switch is located on the
BOTTOM of the unit below the front panel.
Pressing the ON/OFF button on the front panel of the heater will switch the FAN on.
Pressing the ON/OFF again selects 1000W low heat setting.
By Pressing the ON/OFF button again the 2000W high heat setting will be selected.
Press again to turn the unit OFF.
The timer can be set from ½ hour to 7 ½ hours by pressing the TIMER button which steps up ½ hour with
each press.
To turn off the unit press the ON/OFF button on the front panel as detailed above or press the RED rocker
switch to the OFF position.
FROM THE REMOTE CONTROL
The remote control requires two AAA batteries. (not supplied)
To switch on the appliance press the red rocker switch to the ON position as detailed above.
Press the ON/OFF button on the remote control to switch on the FAN.
Pressing the 1000W button will select the low heat setting.
Pressing the 2000W button will select the high heat setting.
The timer can be set from ½ hour to 7 ½ hours by pressing the TIMER button which steps up
½ hour with each press.
To turn off the unit press the ON/OFF button.
ATTENTION.
When the unit is switched off the unit will continue to blow cool air for 30 seconds before
shutting down.
A thermal overload protector is built into the unit to prevent over-heating. If the unit overheats it will shut
down automatically.
