Manual for KinetiZ 7L
Wake-Up On Internal Modem (WOM)
Through the Wake-Up On Internal Modem function, the system which is in the power-off
status can be powered on by a ring signal received from the internal modem. If this function
is to be used, be sure an internal modem card which supports the function is used. Then
connect this header to the relevant connector on the modem card, set Modem Ring Resume as
Enabled in the POWER MANAGEMENT SETUP section of the BIOS. Save & exit, then boot
the operating system once to make sure this function takes effect.
Wake-Up On LAN (WOL)
Through the Wake-Up On LAN function, a wake event occurring from the network can
wake up the system. If this function is to be used, please be sure an ATX 2.01 power
supply of which 5VSB line is capable of delivering 720mA, and a LAN adapter which
supports this function are used. Then connect this header to the relevant connector on the
LAN adapter, set Modem Ring Resume as Enabled in the POWER MANAGEMENT SETUP
section of the BIOS.( On-board RTL8100 LAN need not use this header) Save & exit, then
boot the operating system once to make sure this function takes effect.
Installation Instruction
Signal for waking up (active low)
1
+5V standby
GND
1
+5V standby
GND
Signal for waking up (active high)
