Manual for Advance 6A/Advance 6B
Wake-Up On LAN (WOL)
Through the Wake-Up On LAN function, a wake event occurring from the network can
wake up the system. If this function is to be used, please be sure an ATX 2.01 power
supply of which 5VSB line is capable of delivering 720mA, and a LAN adapter which
supports this function are used. Then connect this header to the relevant connector on the
LAN adapter, set “Wake up on by Ring/LAN” as Enabled in the “POWER MANAGEMENT
SETUP” section of the BIOS. Save & exit, then boot the operating system once to make sure
this function takes effect.
Wake-Up On Internal Modem (WOM)
Through the Wake-Up On Internal Modem function, the system which is in the power-off
status can be powered on by a ring signal received from internal modem. If this function is
to be used, be sure an internal modem card which supports the function is used. Then
connect this header to the relevant connector on the modem card, set “Wake up on by Ring/
LAN ” as Enabled in the “POWER MANAGEMENT SETUP” section of the BIOS. Save & exit,
then boot the operating system once to make sure this function takes effect.
Internal Audio Connectors (AUX, CDLIN, MODEM)
AUX and CDLIN connectors allow you to receive stereo audio input from such sound sources as a
CD-ROM, TV tuner, or MPEG card. The MODEM connector allows the onboard audio to interface
with a voice modem card with a similar connector. It also allows the sharing of mono_in (such as a
phone) and mono_out (such as a speaker) between the onboard audio and the voice modem card.
1
+5V standby
GND
Signal for waking up (active low)
chapter 2
1
+5V standby
GND
Signal for waking up (active high)
