6. Installation and connection
If you purchase a regulator from authorized dealers, you will be
offered a paid or free (bonus) installation and connection of a
new regulator.
Otherwise, use the services of a qualified electrician.
1. Unpack the regulator. If it was transported in the cold season
or stored in a cold prеmіsеs, keep for at least 5 hours in a
room at room temperature to equalize the temperature and
dry the possible condensate water
2. Prepare a place for installation. The main placement of the
regulator is a vertical suspension on the wall. To do this, the
removable (upper) suspension bracket must be fixed to the
wall. Do not install on walls made of flammable materials.
ATTENTION! Before fixing the strip, make sure that
ATTENTION! Before fixing the strip, make sure that
there are no power lines running through where the strip
there are no power lines running through where the strip
to be fixed. It is desirable to use special equipment or
to be fixed. It is desirable to use special equipment or
check the site plan.
check the site plan.
If you are not sure if there are any power lines in this
If you are not sure if there are any power lines in this
area, change the installation location!
area, change the installation location!
3. Switch off the input circuit breaker at the switchboard!
There should be no voltage on the input phase during
connection and installation of the regulator. Conduct checks
only with specialized devices, such as a multimeter in the
"phase search" mode or an indicator screwdriver.
Do not check for a phase with hands. It is dangerous to your
health and can lead to serious injury or death..
4. Remove the two screws and the cover covering the
connection terminals.
5. Strip and lug the protective ground wire and secure it to the
screw next to the terminal in the terminal compartment.
6. Strip and lug the three wires for each appliance - mains phase,
mains neutral (which is also a zero output), and output load.
The length of the wires should be as small as possible and,
if possible, not exceed one - a maximum of one and a half
meters.
13
13
QUANT-7
Automatic voltage regulator, one-phase
