Chapter 3
Chapter 3
Getting Started
Power Connection
DC Power
1. Make sure the power distribution to the DC power feed wires is disconnected.
2. Loosen the screws securing the terminal block to the DC inlet as shown and
remove it from the chassis.
Figure 9 Loosen screws securing DC terminal block and remove from chassis
3. Remove just enough insulator material from the ends of the wires to allow a
proper electrical connection to the terminal block.
4. Insert the power feed wires into the terminal block and tighten the compression
clamps as shown. Insert the terminal block into the DC inlet in the chassis and
secure by tightening the screws loosened in Step 1.
Figure 10 Tighten the terminal block compression clamps, insert into the DC inlet and secure
5. Connect the power distribution to the DC power feed wires.
21
OPC-1500/1700 User’s Manual
