5
Step 9: Attach top panel [A] to the unit as shown in Fig. I with 5 KD screws.
Fig. I
bAck
Step 10: Tighten all KD screws.
Step 11: Carefully move the assembled unit to the desired location. The fireplace mantel
should not be positioned in area exposed to direct sunlight.
WAll ANcHOr SAFEtY cABlE
The use of wall anchor safety cable is highly recommended in order to reduce the risk of
the fireplace being tipped over accidentally.
WARNING: This cable may reduce possible risk of injury if the fireplace is
improperly handled, but is not a substitute for proper adult supervision. Children
should not be left unattended near any heater.
Step 1: Drill a 5/16 in (8 mm) hole in the wall. Insert the plastic wall anchor into the hole
and gently tap until the flange on the anchor is against the wall surface.
Step 2: Position the back edge of the mantel close to the wall.
Step 3: Attach the safety cable to the mantel using the screw for mantel.
Step 4: Use the screw for wall to attach the other end of safety cable to the wall.
Step 5: Make sure all screws are tight.
Fig. J
bAck
OPErAtiON
After reading complete instructions, confirm all controls on fireplace are in the OFF
position. Plug the fireplace into a 15 AMP / 120 Volt outlet. If the cord does not reach,
you may use an extension cord rated for a minimum of 1875 WATTS. Once the fireplace
insert has been properly connected to a grounded electrical outlet, it is ready to operate.
OPErAtiON BY tHE cONtrOl PANEl
The controls are located behind the grill below the front glass and can be accessed by
pulling the grill from the top, forward and down.
WARNING: DO NOT TOUCH. HOT SURFACE AT CENTRE OF GRILL. HANDLE LEFT OR
RIGHT SIDE OF THE GRILL WHEN PULLING OUT.
O/I:
Press this button for main power function and flame effect. See below for other
control switches.
750W:
For low heat function – Press this switch while the O/I switch is in the ON position
for low heat. The indicator light will turn on.
1500W:
For high heat function – Press this switch while the O/I switch and 750 switch
are in the ON position for high heat. The indicator light will turn on.
Temperature Control:
To adjust the temperature to your individual requirements, turn
the temperature control dial to the right (clockwise) to increase the desired temperature
and to the left for lower temperature. This temperature control dial can only be used while
the O/I switch and 750W / 1500W switches are in the ON position. When the heater
reaches the desired temperature, the heater and 750W / 1500W indicator light will turn
off but the fan will continue to operate. Adjust this knob to restart the heater.
Dimmer Control Knob:
Turn the dimmer dial clockwise or counter clockwise to get the
desired flame intensity. The dimmer switch can only be used when the O/I switch is in
the ON position.
NOTE:
When the O/I switch is turned off, all other heater functions will stop even though
the switches may be in the on position.
NOTE:
In order to shut down the heater safely, it is recommended to turn the temperature
control knob to lowest setting and allow the heater to cool down before press the O/I
switch to off position.
