3
MANtEl ASSEMBlY:
CAUTION:
Place a piece of cardboard or protective sheet on the floor in order to avoid
scratching the decorative surface of your mantel during assembly.
Please DO NOT fully tighten the KD screws until all panels are assembled.
Step 1: Attach 2 connectors [S] to upper front panel [E] with 4 KD screws [W].
See Fig. A (2 KD screws for each side).
NOTE:
If the KD screw(s) do not fit during assembly, loosen the 2 screws to adjust the
plastic connector until the panels/KD screws can be installed.
Fig. A
bAck
Step 2: Attach all plastic connectors [X] to panels C, D and E as shown in
Fig. B (2 KD screws for each plastic connector).
NOTE:
If the KD screw(s) do not fit during assembly, loosen the 2 screws to adjust the
plastic connector until the panels/KD screws can be installed.
Fig. B
bAck
Step 3: Attach panels C to panels D with 6 KD screws. See Fig. C.
Fig. C
bAck
Step 4: Attach panels C and D to panel B with 4 KD screws. See Fig. D.
Fig. D
bAck
