3
MANtEl ASSEMBlY:
CAUTION:
Place a piece of cardboard or protective sheet on the floor in order to avoid
scratching the decorative surface of your mantel during assembly.
Please DO NOT fully tighten the KD screws until all panels are assembled.
NOTE:
Each plastic connector is pre-assembled (pre-drilled) on the specific panels with 2
screws. If the KD screw(s) do not fit during assembly, loosen the 2 (pre-drilled) screws to adjust
the plastic connector until the KD screws are able to be installed. Tighten all KD screws once all
panels are assembled.
Step 1: Attach 11 plastic connectors [X] to panels C, E, F, G, H, J and K as shown in Fig. A (2
pcs KD screws for each plastic connector). Attach panels H and K together with wood
connector [P] and 4 KD screws. Attach panels G and J together with wood connector
[P] and 4 KD screws. See Fig A.
Fig. A
BACk
Step 2: Attach panel E to panel G and J with 1 KD screw. Attach panel F to panel H and K with
1 KD screw. See Fig. B.
Fig. B
BACk
Step 3: Attach 2 x wood connectors [P] to panel E and F with 4 KD screws (2 screws for each
wood connector). Attach panels E, G and J to base panel [B] with 2 KD screws. Attach
panels F, H and K to base panel [B] with 2 KD screws. See Fig. C.
Fig. c
BACk
Step 4: Attach lower front panel [D] to the unit as shown in Fig. D with 2 KD screws. See Fig. D.
Fig. D
BACk