SOFTPRO INSTALLATION GUIDE
©2020 Quality Water Treatment. All rights reserved.
17
.
STEP 8)
Install the bypass valve to the control valve.
a)
Remove the two red clips from the rear of
the SoftPro control valve.
b)
Press the bypass valve into the rear of the
SoftPro control valve.
c)
Reinstall the red clips. Gently tug on the
clips to make sure they are locked into
place.
STEP 9)
Connect the brine line to the control valve.
a)
Insert the plastic sleeve (this can be found
on the thin wire holding the vanilla tag on
the brine line elbow). Only hand tighten the
brine line nut to the elbow fitting.
STEP 10)
Connect the drain line to the control valve.
WARNING:
Do not remove the drain line
elbow or fitting from the rear of the control
valve.
(This fitting includes the drain line flow
control. If removed, the system will not work
properly, and the resin will drain out when the
system regenerates.)
WARNING
: Do not install the drain line more
than 3 feet above the control valve.
