QUALITY LIFTS Q12, Инструкция по установке, эксплуатации и обслуживанию

Страница: 2 / 21

Model Q12
Installation, Operation and Maintenance
Page 2
Rev. 02/01/15
Q12-IOM-Q.
doc
G
ENERAL
S
PECIFICATIONS
* Lift capacity ratings are based on loads equally distributed on all four arms.
** Lifting and lowering speeds may vary depending on the weight of the vehicle.
Fig 1a - General Specifications Fig1b - Service Bay Lay
out
See Figure 1 Q12 Q12 w/ 2 Ft. Ext. Kit
A Rise Height (Screw Pads Highest Position) 77 3/4"
(1975 mm)
B Overall Height 13’-10"/14’-7”
(4216 mm/4445 mm)
15’-10"/16’-7”
(4826mm/ 5055mm)
C Overall Width 139 3/4"
(3550 mm)
D Drive-Thru Clearance 103"
(2616 mm)
E Floor to Overhead Switch 13’-3 ½"/14’-½”
(4051mm/4280 mm)
15’-3 ½"/16’-½”
(4661mm /4890mm)
F Minimum Arm Reach 35 3/4"
(910 mm)
G Maximum Arm Reach 54 1/2"
(1386 mm)
H Screw Pad Height 5 1/4"/ 6 3/4"
(133mm/171mm)
K Inside of Columns 115"
(2921 mm)
Lifting Capacity *
(Hydraulic Pressure at Cap.)
12,000 lbs.
(2600 psi)
Ceiling Height Required 167"/176”
(4242mm/4470mm)
191"/200”
(4852mm/ 4890mm)
Motor 2HP, Single Phase, 60Hz
Voltage 208-230
Speed of Rise ** 66 seconds
Max Load Per Arm 3000 lbs
(1360 kg)