6
•
Keep the machine in optimal conditions of cleanliness is a daily requirement for guaranteeing the necessary hygiene and good
quality of the final beverage, as well as a longer service life for the machine.
Cleaning and Daily Care
4.
-
Keep the machine clean using a wet cloth or
a sponge moistened with a soapy solution.
Use mild and non-corrosive detergents, and
cloths that do not scratch. Take special care
of the areas related with the product, steam
arm, hot water output.
4.1 Cleaning
-
Avoid reheating the milk. Heat up small amounts.
-
Before heating the milk open the steam to drain. Once the operation
is finished, drain once again and clean the tune with a wet cloth.
Practical Advice
Hot water and steam supplies
5.
•
Open the hot water tap until you obtain the amount you want and then
close the tap.
•
To move the hot water arm and avoid possible burns, use the handle
(Fig.1)
5.1 Hot water supply for teas
To heat up liquids
:
•
Drain the steam arm. To do so open the steam tap until there is no
condensed water left in the tube and then close the steam tap. This
operation must always be carried before using the steam output and
after each use.
•
To move the steam arm use the silicone protector incorporated to the
arm.
•
Submerge the steam arm to the bottom of the container used and open
the steam tap at will until the temperature desired is reached. Once this
temperature has been reached, close the tap.
•
Immediately clean the steam output with a wet cloth in order to keep the
latter clean.
5.2 Steam supply to heat up liquids or boil milk
To emulsify milk:
•
Choose a suitable jug for the amount of milk you want to emulsify, fill it with the appropriate amount.
•
Drain the steam arm, following the instructions of the previous paragraph.
•
To move the steam arm use the silicone protector incorporated to the arm.
•
Place the nozzle of the steam arm on the side of the jug, approximately 0.5 cm above the milk.
•
Turn the steam tap until it is fully open and wait until the milk increases its volume, without heating it up too much.
•
Close the steam tap and once the jug has been removed, drain and clean the steam output as explained in the previous
paragraph.
Fig.1
Silicone protector
