2
1.1 Symbols
We ask you to carefully read this instruction manual before operating your new water/steam dispenser for the first time.
Keep these instructions in a safe place where you can consult them when necessary.
The inappropriate use of this machine exempts Quality Espresso from any liability.
1.2 Safety instructions
•
The Dispenser should only be installed by authorized technical personnel. The manufacturer
declines any liability for possible injuries caused by inappropriate installation
•
The use of gloves is recommended to manually move the machine to its installation site
•
The Dispenser should be stored in areas with a temperature higher than 5º C.
•
In the event of storage or transport of the machine in temperatures lower than 0º C, and in order to
prevent freezing, the Dispenser’s hydraulic circuit should be emptied first.
•
In the event of freezing, the Dispenser should be placed in an area with a temperature higher than
10º C to wait for unfreezing. Under no circumstances should the machine be connected to the
electrical circuit before it is unfrozen.
•
It is recommended that the Dispenser is installed in a spacious area, free of air currents and with a
solid base. Avoid installing the machine on a wet or hot surface.
•
Regulate the height of the Dispenser with the support legs. Maximum inclination cannot be greater
than 1º between any of its axes.
•
Check that all of the electrical connection characteristics comply with the voltage, frequency and
wattage indications described on the Dispenser’s specification plate. This plate is located on the
chassis under the drainage tray
•
We consider the Dispenser to be installed correctly when it has been connected to a magneto-
thermic omnipolar circuit breaker appropriate to the Dispenser’s power, along with a differential
that does not exceed a residual current of 30 mA.
•
The Dispenser must be installed in accordance with the current electrical regulations of your area.
You must make ensure that the electrical installation is reliably grounded in accordance with the
aforementioned regulations. The company declines any liability for possible injuries caused by a
defective installation or incorrect ground connection.
•
Extension cords or outlet adapters of any kind should not be used to connect the Dispenser to the
power supply. The connection cable should never be rolled up, but instead it should be fully
extended to avoid possible overheating.
Safety Indications
1.
Installation
Transport
Storage
Placement
Electrical
connection
WARNING
May cause injuries
INFORMATION
Important or useful information
!
i
RISK OF ELECTRIC SHOCK
May cause injuries
