3
MANTEL ASSEMBLY:
CAUTION: PLACE A PIECE OF CARDBOARD OR PROTECTIVE
SHEET ON THE FLOOR IN ORDER TO AVOID SCRATCHING THE
DECORATIVE SURFACE OF YOUR MANTEL DURING ASSEMBLY.
PLEASE DO NOT FULLY TIGHTEN THE KD SCREWS UNTIL ALL
PANELS ARE ASSEMBLED.
NOTE: EACH PLASTIC CONNECTOR IS PRE-ASSEMBLED (PRE-
DRILLED) ON THE SPECIFIC PANELS WITH 2 SCREWS. IF THE
KD SCREW(S) DO NOT FIT DURING ASSEMBLY, LOOSEN THE 2
(PRE-DRILLED) SCREWS TO ADJUST THE PLASTIC CONNECTOR
UNTIL THE KD SCREWS ARE ABLE TO BE INSTALLED. TIGHTEN
ALL KD SCREWS ONCE ALL PANELS ARE ASSEMBLED.
Step 1: Attach 13 plastic connectors [X] to Panel C, D E, F and G
with 26 KD screws [W] as shown in Fig. A. (2 KD screws [W] for
each plastic connector). Attach 2 wood connectors [S] to panel C
with 4 KD screws [W] (2 KD screws for each wood connector).
See Fig. A.
Fig. A
Step 2: Attach left front panel [D] to left side panel [F] with 2 KD
screws. Attach right front panel [E] to right side panel [G] with 2
KD screws [W]. See Fig. B.
Fig. B
Step 3: Attach left front panel [D] and left side panel [F] to base [B]
with 3 KD screws [W]. Attach right front panel [E] and right side
panel [G] to base [B] with 3 KD screws [W]. See Fig. C.
Fig. C
Step 4: Attach upper front panel [C] to left and right front panel [D
and [E] with 2 KD screws [W]. See Fig. D.
Fig. D
