2
CONTROL, A PROGRAM CONTROLLER, A TIMER OR ANY OTHER
DEVICE THAT SWITCHES THE HEATER ON AUTOMATICALLY,
REMEMBER TO OBSERVE ALL SAFETY WARNINGS AT ALL
TIMES. THE FIREPLACE HEATER HAS SAFETY OVERHEAT
PROTECTION. IF THE OVERHEAT PROTECTION TRIPS, SWITCH
OFF ALL SWITCH BUTTONS AND WAIT APPROxIMATELY 5 -10
MINUTES. IT SHOULD RESET AUTOMATICALLY ONCE THE UNIT
COOLS DOWN.
WARNING: PROCEDURES AND TECHNIqUES IF NOT CAREFULLY
FOLLOWED WILL RESULT IN DAMAGE TO THE EqUIPMENT AND
WILL ExPOSE THE USER TO THE RISK OF SERIOUS INJURY,
ILLNESS OR DEATH.
This electric fireplace heater is for use on 120 volts. The cord has
a plug as shown at A in illustration below. An adapter as shown
at C is available for connecting three-blade grounding-type plugs
to two-slot receptacles. The green grounding plug extending from
the adapter must be connected to a permanent ground such as a
properly grounded outlet box. The adapter should not be used if a
three-slot grounded receptacle is available.
A 15 AMP circuit is required to operate this heater. If the breaker
trips when the heater is used then you may need to move the
heater to another location or unplug other appliances that are on
the same circuit. If you require an extension cord use one that is
rated at 1875 watts.
ASSEMBLY INSTRUCTIONS
PARTS LIST
qTY
Fireplace insert ........................................................................1
A) Top panel.............................................................................1
B) Base panel ..........................................................................1
C) Upper front panel .................................................................1
D) Mid-front panel ....................................................................1
E) Left front panel ....................................................................1
F) Right front panel ..................................................................1
G) Left side panel .....................................................................1
H) Right side panel ...................................................................1
J) Pillars .................................................................................2
K) Decorative box .....................................................................2
Q) Spacers ..............................................................................2
R) KD screws .........................................................................46
S) Mounting Screws .................................................................4
U) Mounting Clips .....................................................................2
V) Mounting Bracket .................................................................2
W)Medium KD Screws ..............................................................4
X) Plastic Connector ...............................................................12
Y) SELF REPAIR SET
Touch-up repair paint (bottle) ....................................................1
L shape bracket .......................................................................2
Screws for L shape ..................................................................8
Plastic connector .....................................................................1
KD screws ...............................................................................3
KD nuts ...................................................................................3
Z) WALL ANCHOR SAFETY CABLE
Wall anchor .............................................................................1
Screw for wall anchor ...............................................................1
Screw for mantel .....................................................................1
Safety cable .............................................................................1
TOOL REQUIRED: PHILLIPS HEAD SCREWDRIVER
