A
Wall Plate
SKIP TO STEP 3
3
4
Installing the Decorative Covers
1
WARNING
Make sure that mounting screws are anchored into the center of the studs. The use
of a stud finder is highly recommended.
Installers are responsible for providing hardware for other types of mounting situations.
Installers must verify that the supporting surface will safely support the combined
weight of the equipment and all attached hardware and components.
F
Decorative Cover
G
ST2.9x6.5 Screw
Mounting to a Wooden Stud Wall
2a
Using an edge-to-edge stud finder, find the
edges of the stud.
1
Using a level, mark the centerline of the stud.
2
NOTE
Do NOT use power drill and do NOT over tighten the lag bolts.
Mount the wall mount (A) and tighten it with the provided
lag bolts (W-A) and
D
6 washers (W-C) using a socket wrench.
5
Attach the decorative covers to the wall mount using the screws.
For concrete wall
mounting, follow
Step 2b.
NOTE
Using the marking template (H) provided,
mark four holes for drilling on the centerline of
the stud.
3
Using a power drill and 3/16" drill bit, drill
pilot holes of 3/16" (4.5 mm) diameter and at
least 2.5" (65 mm) depth.
4
ø 4.5mm
(ø 3/16")
(2.5")
65mm
(2.5")
65mm
H
QG-TM-03
2-BLK
Stud Finder
When decorative covers are installed correctly,
there will be a gap between the bottom of the wall
plate and the decorative covers. This gap is for the
safety bar installation on Step 5.
NOTE
W-A
W-C