Qualcut RA0038LS, Руководство по эксплуатации

Страница: 13 / 20

RA0038LS
13.
!
WARNING!
Read and understand these operating
instructions, as well as the information supplied with
your machine, and follow all warnings and safety
instructions. Failure to do so can result in serious injury
to the operator and/or bystanders.
Fig 1.
Fig 2.
Leave approx.
3 inches
There are 2 holes on spool drum
Fig 3.
Fig 5.
NOTE: Do not let the lines loosen.
Fig 4.
Leave 4-6 inches of lines from the notch.
NOTE: Do not let the lines loosen.
• To advance the nylon line, bump the downward
protruding button onto the ground while maintaining
engine speed.
• Do not bump the head to attempt to feed line when
operating the machine above 4500 revolutions per
minute.
• Optimum cutting speed is approximately 5000
revolutions per minute.
• If the head does not properly extend nylon line, check
the head for damage and rewind cutting line.
Rewinding the Head
1. Remove the cover by depressing the locking tabs located
180 degrees opposite of each other (Fig 1).
2. Remove the line spool from the housing.
3. Fold 18ft. of cutting line in two halves, leaving one half 3
inches longer than the other, (the three additional inches
will make the line even on both sides of the head when
wound on the spool).
4. The spool is divided in the center and has a slot to
accommodate the folded portion of the nylon line (Fig 2).
5. Wind the line firmly with one strand on either side of the
center divider according to the directional arrow indicated
on the spool (Fig 3).
6. Hook the line strands to the line holding notches on one
of the outer flanges of the spool. This will help to hold the
line in place while the spool is installed in the body of the
head (Fig 4). Leave 4 - 6 inches of the lines protruding
from the notches.
7. The tension spring should stay in the housing hub. Put
the spool onto the housing, positioning it to move up and
down freely against the spring tension.
8. Put the lines into the respective eyelets (Fig 5 & 6).
9. Put the cover onto the housing, aligning the locking tabs
on the cover. Make sure the tabs are fully locked into
place in the cover (Fig 7).
THE LINE TRIMMER HEAD