11
10
Customer Helpline
0845 034 2279
www.gardenservicecentre.co.uk
Customer Helpline
0845 034 2279
www.gardenservicecentre.co.uk
Operating the Hedge Trimmer
Step 2 - Cutting
WARNING !
Cut and remove branches DO NOT exceeding the cutting capacity of this product .
With its unique design the pole Trimmer can be used to trim and shape hard to reach areas of
hedges and bushes such as those shown in figure below .
Step 3 - Adjusting the working height
Preparing to Operate the Hedge Trimmer
This pole length of appliance can be adjusted by separating the intermediate pole from the
appliance .
1. Loosen the thread sleeves of intermediate pole
2. Take out the intermediate pole from the appliance
3. Attaching the pole handle to the powerhead pole , When inserted, the arrow (A) should align with
the arrow (B), and must be inserted fully. as shown in Fig.A on page 5 in Assembly Manual.
4. Tightening the locking knob in the “LOCK” direction. (IMPORTANT: Must turn the locking knob
tightly.).
Operating the Hedge Trimmer
Step 1 - Switch on /off
NOTE !
For your safety, this tool is equipped with a double switch system. This system prevents
starting the tool inadvertently. You must push the Lock-off button (A), and then press the On/off
switch (B).
Switching on
• Push the Lock-off button (A).
• Press the On/off switch (B) and release the Lock-off button (A).
Switching off
• Release the On/off switch (B).
NOTE!
Never attempt to lock the switch in the “on” position.
Stopping
Stopping
Release the trigger (A),and the blade will stop in 2 seconds.
B
A
A
