![background image](http://html1.mh-extra.com/html/qualcast/ggt450a1/ggt450a1_assembly-manual_3399621018.webp)
Customer Helpline
0344 801 0979
18
ORIGINAL INSTRUCTIONS
When refitting the spool cap.
Keep all areas of the cap and spool holder clean.
Replace the cap, pressing firmly down towards the spool holder to ensure cap is fully located.
Check that the cap is correctly fitted by trying to remove it without depressing the two latches.
Take approximately 3 metres of line. Insert 15mm of line into one of the holes in the upper section
of the spool and wind line in the direction of the arrows on the top of the spool.
Leave approximately 100mm of line unwound and place into cleat. Repeat on lower section of
spool.
Care should be taken to ensure that the line is neatly coiled on the spool. Failure to do so will impair
the efficiency of the automatic line feed.
Then fit spool as described in “To fit spool and line complete”.
WIND SPOOL WITH NEW LINE (SEE Q, R, S)
Important! Your trimmer is designed to use only line with a maximum diameter of 1.65mm.
1. Remove the empty spool from the tool as described in “TO REPLACE CUTTING LINE” above.
2. Remove any remaining cutting line from the spool
3. IMPORTANT - Always wind the line onto the upper section of the spool first. Take approximately 3
metres of line. Insert 15mm of line into one of the holes in the upper section of the spool and wind
line in the direction of the arrows on the top of the spool.(SEE Q, R). Leave approximately 100mm
of line unwound and place into cleat (b). Repeat on lower section of spool. Care should be taken to
ensure that the line is neatly coiled on the spool. (SEE S) Failure to do so will impair the efficiency of
the automatic line feed. Then fit spool as described in “To fit spool and line complete.
Step 3 – Inserting The Line Spool
How To Replace The Spool/Spool Line
Step 2 – Replace The Cutting Line (Continued)
a
Содержание GGT450A1
Страница 24: ......