![background image](http://html1.mh-extra.com/html/qualcast/ggt450a1/ggt450a1_assembly-manual_3399621015.webp)
Customer Helpline
0344 801 0979
15
ORIGINAL INSTRUCTIONS
Operating the Grass Trimmer
b
Push 3
5
10
A
A
B
a
A
B
C1
C2
D
E
F
G1
G2
H
I
J
K1
K2
L
M
N
O
P
b
Push 3
5
10
A
A
B
a
A
B
C1
C2
D
E
F
G1
G2
H
I
J
K1
K2
L
M
N
O
P
TRIMMING
Do not cut wet grass because it tends to stick to the trimmer head and guard, prevents proper discharge
of grass clippings, and could cause you to slip and fall.
Regularly remove clippings and dirt around the trimmer head with a switched off trimmer.
Work rhythmically, stand firmly with your feet apart. Cut from right to left so the trimmings will be thrown
away from the work area.
Do not move the trimmer too fast as this will result in ineffective cutting and possible damage.
Cut repeatedly from up and down in layers when the grass is very high. Keep the trimmer head at an
angle of about 30°to the ground when trimming. Avoid pressing it against the ground as this can ruin the
lawn and damage the trimmer head.
If you find that the nylon line is too short follow the instruction as in “Automatic line feed system’’ or “To
manually feed the line”.
NOTE: Let the cutting device do the work. Let it work at its own space, never press it into the area to be
cut.
Change the tool from trimming to edging mode by adjusting the cutting angle to be in the lowest
horizontal setting as shown.. Then push the Handle rotation locking button downward and rotate the
main handle 90 degree clockwise
Then position the wheel on the ground for edge mode. The guard has two white line guides to indicate
the cutting line position. Align these marks with the edge of your lawn.
While edging, only allow the tip of the line to make contact with area being worked. Do not force the
line. The edging wheels help protect the unit and keep the unit from contacting the ground. Take extra
caution while edging as objects can be thrown from the trimmer line.
When initially switching on the trimmer, a small length of line is fed out.
A ‘clattering’ noise will be heard when the lines hit the line cutter. DO NOT BE ALARMED this is quit
normal. After about 5 seconds the line will be cut to the correct length and the noise will reduce as the
motor receives full speed. If the noise of the line being cut can’t be heard, more line will be fed out.
To feed more line, it is first necessary to allow the trimmer to stop completely, then restart, allowing the
motor to reach full speed. Repeat above 4 until you hear the lines hitting against the line cutter. (Do not
repeat this procedure more than 6 times)
Step 3 – Edging
Step 4 – Automatic line feed system
Step 2 – Trimming(continued)
Содержание GGT450A1
Страница 24: ......