PUMP JACK
MODEL # 2200
PUMP JACK
SYSTEM
Customer Supprt and Ordering In for ma tion
781-344-1000 • www.qualcraft.com
the original brace is reinstalled. 2) Remove the nails holding
the original pump jack brace to the pole along with the wing
nut and carriage bolt. 3) Let the brace arms swing down and
away from the pole. Do not remove brace from wall. 4) Move
platform and reinstall brace.
Care and Maintenance:
Inspect all pump jack equipment including the pump jack pole
before and after each use to be sure that there is no damage,
deformation or deterioration due to rusting or extensive use to
any of the equipment’s components. 2) Pay special attention
to the pump jack poles to insure that they are in good condi-
tion at all times. If any splitting or deterioration takes place
discard at once. 3) Do not throw or drop from building or onto
a truck any of the pump jack equipment. Always handle with
care. 4) Do not use equipment if it has been exposed to ex-
treme heat or cold, discard at once. 5) Do not use equipment
if wet or frozen. 6) Federal regulations require the user to have
knowledge of all regulations that apply to the use and care of
this product and that the employer provides training.
THIS PRODUCT MUST BE USED IN STRICT COMPLIANCE
WITH LOCAL, STATE AND FEDERAL OSHA REGULATIONS.
BE SAFETY CONSCIOUS.
© Copyright 2001 QUAL-CRAFT INDUSTRIES, INC. Stoughton, MA 02072
Failure to read and follow instructions on the use of this product could result in serious
personal injury. To prevent an unstable scaffold that could lead to serious personal
injury:
•
Poles must not exceed 30 feet in height.
•
Mending plates must be installed at all splices.
•
Poles must be secured using rigid triangular steel bracing at top, bottom and at 10
ft. intervals.
This product must be used in strict compliance with Local, State and Federal OSHA Regula-
tions.
Crank Handle Lock to Raise Release to Lower
Foot Pedal - Always leave stirrup in the up position when at working level or
when
descending Pole.
Failure to follow these instructions could result in an unexpected drop when the lower pedal
is released.
