Step 8
FIG 55
FIG 54
FIG 53
FIG 52
FIG 51
FIG 50
FIG 49
FIG 56
Installing the Top to the Jeep® Body
Starting at the driver’s side front, right behind the front seat, attach the front vertical belt rail into the door surround slot
by “rolling the plastic into the slot
(FIGs 49 & 50).
Once secure move to the rear driver’s side corner and “roll” the plastic into the Jeep body corner belt rail as shown in
FIGs 51 & 52. Repeat this procedure on the passenger side.
Once both corners are secured, “roll” the plastic on the bot tom of the quarter windows into the body belt rail as shown in
FIGs 53 & 54.
NOTE: as shown in FIGs 55 & 56 there is a web loop insta lled on the side of the quarter window.
This is to be used for unhooking the quarter window only and is not designed to be pulled down on for installation!
Repeat the quarter window install on the passenger side of the vehicle. You may have to pull the corners around
towards the front or back of the vehicle to center the top on the vehicle. Once all body belt rail attachments are secure
and the top is centered, you can now reach through the rear zipper on each side and tighten the corner straps.
Alternate tightening to keep the top centered. Seal hook and loop around windows.
Step 9
Locate the two plastic strips sewn to the sides of the top above each door (FIG57).
Starting with the front strips, slip the strips into the channel in the door surround above the door opening (FIGs 58 & 59).
Secure the strips on each side of the vehicle. When com plete each side should look like FIG60.
FIG 57
FIG 60
FIG 59
FIG 58
Secure the Over Door Attachments
