Locate the “C” clamps on the upper horizontal over door section and line them up with the holes in the horizontal tubes of the roll
bar. Press the “C” clamps onto the horizontal tubes and the front portion of the door surrounds forward into the rubber gasket on the
windshield (FIGs 11& 12).
With the door open, stand on the door sill and locate the two “C” clamp holes. Screw in a Door surround knob into each “C” clamp
into the horizontal tube of the roll bar (FIGs 13 & 14).
Secure the knobs tight. Repeat on passenger side.
Step 3
Installing the Header and Top Deck Assembly to the Door Surrounds
Locate the Header and Top Deck assembly completed in step one. With the help of a friend, place the header/Deck assembly on the
vehicle locating the front header on the top of the windshield and the rest of the fabric spread back on the rear of the vehicle (FIG15).
Under the fabric, locate the over door bow installed in step one and place the quick release end in the top front hole of the pre-in-
stalled bow mount bracket pulling the knob out until you hear a “click” (FIGs 16, 17, 18 & 19).
FIG 11
FIG 12
FIG 13
FIG 4
FIG 15
FIG 16
FIG 17
FIG 18
After installing the side tubes to the door surround brackets please check the location of the front header to make
sure it its snug and does not “over-hang” the front of the windshield. Please see page 8, Step 11 for a visual repre-
sentation of the correct header location.
NOTICE
FIG 20
FIG 19
Repeat this on the opposite side of the vehicle and fold back the front portion of the top as shown in FIG20.
