Winch Hook Assembly
Pull the Cable through the Fairlead and
connect the Hook and Safety Pin. Attach
winch hook to the winch cable as shown
using the cotter pin. Spread the cotter pin
ends to secure the hook.
Clocking Instructions
For some winch installations, it may be
necessary to rotate the gear housing to
make room for clutch handle operation.
To rotate the gear housing, remove all the
11 socket cap screws using a 4mm allen
key. Rotate the gear housing to the
desired location and reinstall the 11
fasteners. Note: There are 12 different
positions at 30° increments allowing a
full 360° rotation.
Thank you for purchasing your
Quadratec
®
Q-Series self-recovery winch!
Your winch should add greater utility and
enjoyment to your off-road adventures.
Keep in mind, however, the weight of
your vehicle and the forces required to
move it create certain hazards. Self
recovery that is safe for you, bystanders
and the environment requires product
knowledge, planning and practice. The
broad conditions where self-recovery is
required make it impractical for this
manual to advise you of all techniques or
hazards associated with winching. Start
with the Q-Series safety information
found in this manual and supplement
your knowledge by consulting off road
technique manuals or more experienced
Jeep
®
enthusiasts.
Develop and rely on your own good
judgment at all times. If you have a
question specific to your purchase, our
customer service staff is standing by at
our #1 rated website quadratec.com or
toll free: (800) 745-6037.
The Trusted Source
®
7
Installation
(Continued)
Congratulations!
Shown:
Clocked at
Zero Degrees
from Factory
4mm HEX Key
HRM_92112_200X_Assembly_12P_Layout 1 2/8/12 4:52 PM Page 7
