The Trusted Source
®
5
Assembly and Installation
(Continued)
Yellow Motor Stator Cable
Green Motor Stator Cable
Red Motor Rotator Cable
Black Thermo Relay Wire
Black Negative Ground Cable
Red Positive Cable
(To Positive Terminal on Battery)
Black Negative Ground Cable
(To Negative Terminal on Battery)
Attach red, yellow and green short cables
to motor terminals as shown. Note: The
three copper terminal stud ends are color
coded. Tighten all three brass nuts onto
terminals using a 13mm wrench. DO
NOT OVER TIGHTEN.
Attach black ground cable to motor ter-
minal and black thermo relay wire with
brass bolt. Tighten brass bolt onto termi-
nal using a 14mm wrench. DO NOT
OVER TIGHTEN.
Fire/Electrical Spark/Chemical Burn Hazards:
Connecting winch to batter y and winch operation may cause electrical arcs.
Never
install
or use winch where gasoline leaks, vapors or other flammables are present.
Always
wear eye protection & remove jewelr y when working with batter y or installing winch
electrical cables. Plan connections to avoid fuel lines, hot or rotating par ts.
Never
route
electrical cable or winch controller across sharp edges, doors or other pinch points.
Always
use supplied terminal boots, insulate any other exposed connections neatly
suppor t all wiring. Depending on your level of knowledge regarding electrical wiring, you
may wish to have this procedure per formed by a qualified technician.
Electric Cable Connection
HRM_92112_200X_Assembly_12P_Layout 1 2/8/12 4:51 PM Page 5
