3
Put on safety glasses. Start by applying
foam pads to the required areas. The
88mm x 12mm narrow pads will be
applied to the Bracket clamps as shown.
(FIG 1)
The 88mm x 25mm pads will be applied
to the main brackets foot as shown.
(FIG 2) The pad needs to wrap around
the foot evenly to protect your hard tops
finish.
FIG 1
FIG 1
FIG 2
FIG 2
The 88mm long thicker pads will be
applied to the main brackets base as
shown to protect your hard tops finish.
(FIG 3) Line up the padding ½” over
from the inside vertical edge as shown.
Loosely install 2 of the supplied M8 car-
riage bolts through the main bracket
and lay them in the drip rail channel on
your hard top. (FIG4) Both pads should
contact the top as shown.
Loosely install the bracket clamp to the
main bracket as shown with a 16mm
OD M8 washer and locking nut using a
13mm deep socket. (FIG 5)
Loosely install 16mm OD M8 washers
and locking nuts to the carriage bolts
as shown using a 13mm socket. (FIG 6)
Repeat steps 1-6 for the other side of the
vehicle.
FIG 3
FIG 3
FIG 5
FIG 5
FIG 6
FIG 6
FIG 4
FIG 4
Installation Instructions:
Q_ROOFBSKT_BRKT_JK_92034_1091_6PG_A4.indd 3
Q_ROOFBSKT_BRKT_JK_92034_1091_6PG_A4.indd 3
8/31/20 3:17 PM
8/31/20 3:17 PM
