Un-zip the roll bar padding towards the rear of
the vehicle just past the rear door surround and
right after the small Velcro flap as shown
Bolt Location
Velcro Flap
Rear Door
Surround
6
FIG2
4
FIG2
5
FIG26
FIG29
FIG28
FIG30
FIG31
FIG32
FIG27
FIG27
a
in FIG24. There will be a factory mounted bolt
just under this flap. Using a 13mm socket and
driver, remove this bolt from the roll bar (FIG25).
Once removed, slip the rear bow bracket over
the hole and replace the bolt. Note in FIGS 26,
27 & 27a the location of the bow when installed.
Repeat this install on the other side of the vehi-
cle and then re-install the roll bar padding. The
rear bow bracket should come right out under
the Velcro flap (FIGS
28
,
29
&
30
).
Step 6: Installing the Rear Bow
Locate he rear bow as circled in FIG22. This
bow is curved at the end and has a flat bracket
welded onto each end as shown in FIG23. This
bow mounts to the factory mounting point on the
rear of the roll bar under the Roll Bar padding
and just behind the rear door surround (FIG 24).
