The Trusted Source
®
Quadratec
®
Vehicle Cover
Installation & Care for Jeep Wrangler Vehicle Covers
#
11081.02XX
These Covers are
not
machine-washable.
Shake cover to remove dust, hose it off to
remove dirt, and spot clean using a mild
soap and water.
In high winds, ensure cover is securely
tied down using the loops, cord and the
cable security kit. In severe conditions, ad-
ditional tie-down cords may be required.
Store cover in the provided storage bag.
Ensure cover is dry before placing in bag
In freezing weather the cover may freeze
to the vehicle. Ensure ice has thawed be-
fore attempting to remove the cover.
Do
not
drive or tow the vehicle with the
cover in place. Do
not
use on a recently
painted vehicle. Allow new paint to cure
for 6 months before using a car cover.
Do
not
install the cover over hot surfaces,
including exhaust pipes.
Should you need to mark the cover with
a license plate number or similar identifi-
cation, use only fabric paint, available at
most craft stores. Do not use regular
paints or permanent markers.
Removal of the radio antenna before in-
stallation of the cover is
strongly
recom-
mended. However, if you do not want to
remove your antenna on a regular basis a
provided grommet can be installed.
Keep in mind that this will
adversely
affect the cover’s ability to keep out water
in this area. Remove the antenna and fully
install the car cover taking special care
that it is aligned evenly over the vehicle.
Locate and mark the location of the base
of the antenna with a pencil.
Remove the car cover. Carefully cut a ½
inch “X” over the mark you made in the
cover. Align the top and bottom halves of
the grommet on either side of the “x” hole
in the cover and rest them against a hard
surface. Firmly press the two halves of the
grommet together until they lock. It may
be necessary to gently strike with a non-
marring mallet in order to engage the two
halves.
For future use make sure the grommet is
slid over the antenna first before installing
the mirrors into the mirror pockets.
Install the cover by unfolding or unrolling
along the length of the vehicle. Fit the
mirror pockets over the mirrors first, then
carefully extend the cover to snugly fit
over each end of the vehicle.
Remove in the opposite order: loosen each
end of the cover first, remove mirrors from
the mirror pockets, then fold the cover
back onto itself before folding or rolling
the cover along the length of the vehicle.
Q_JEEP_CVR_UPDATE_A4.qxp_Layout 1 1/8/18 10:55 AM Page 1
