Page 24
7075-205
April 29, 2013
R
Voyageur Grand
F. Standard Surround & Trim Kit Installation
Standard Size: 1092 mm W x 787 mm H
Large Size: 1295 mm W x 864 mm H
1. Lay surround face down on a protected surface to pre
-
vent scratching.
2. Using a 102 to 152 mm long Phillips head screw driver
attach the side surrounds to the top surround using (2)
#8 sheet metal screws on each side provided with the kit.
Figure 21.2
.
3. Lay the trim face down and place the corner brackets into
position.
4. Using a standard flat screw driver tighten the corner
brackets.
Figure 21.3
.
5. Slide the assembled trim set over the surround set. and
then over the appliance matching the mounting tabs on
the side pieces with the slots on the appliance.
Figure
21.2.
6. Align the 2 screws in the top surround piece to the 2
alignment holes on the appliance top. Secure in place.
Figure 21.2
.
7. Use the strain relief in the surround side for blower cord
installation and use the cover plug to insert into the hole
where the blower cord is not installed.
Figure 21.2
Corner Brackets
Figure 21.3
E. Securing Appliance to Stove Pipe/Liner
1. Once you have the appliance in place and secured,
remove the tube channel assembly, baffle board and
ceramic blanket. Detailed instructions are found on
pages 9 and 10.
2. Reach up through the flue opening and grab the attach
-
ment bar and pull down inside flue opening.
Figure
21.1
3. Insert the 5/16 bolts inside the cast flue and through the
chimney mounting bar. Securely tighten the nuts. Fas
-
teners are provided.
4. Re-install the tube channel assembly, baffle board,
ceramic blanket and baffle protection channel.
Figure 21.1
5/16 Nuts
Attachment
Bar
5/16 Bolts
Strain Relief for
Blower Cord and
Cover Plug for hole
in each side
Secure 2 Sides to Top
Mounting Tabs
Slide into Slots
on Firebox Face
Secure to
Firebox Face
Heat Deflector