29
April 2, 2019
7050-802B
SANTA FE FREESTANDING
F. Glass Replacement
PART NUMBER:
SRV7021-032
1.
Open the face and remove door from the appliance by
lifting door off of hinge points and lay on a flat surface
face down.
2.
Using a flat head screwdriver pry out rope from door
and clean any silicone around the screw heads.
3.
Using a Phillips head screwdriver remove the seven
screws and set aside.
4. Remove glass retainers and set aside.
5.
Remove old glass assembly and discard.
6. Lay new glass assembly in place.
7. Add glass retainers.
8.
Using a Phillips head screwdriver fasten glass retainers
to door assembly ensure glass assembly is centered
within the frames.
9. Add rope into crevice as shown below in
Figure 29.2.
10.
Re-install door and close face to appliance.
Figure 29.2
Screws
Rope
Glass Retainers
Glass
Assembly
Door Assembly
E. Igniter Replacement
PART NUMBER:
SRV7000-462
1. Shut down the appliance by turning down the
thermostat
and let the appliance completely cool down
.
After the appliance has cooled down, unplug it and
remove the ash drawer.
2. Remove side panel.
3. The wire leads to the igniter are connected to the wire
harness with 1/4 inch male / female spade connectors.
Disconnect the spade connections. Loosen thumb
screw and slide igniter out and remove the igniter from
the chamber.
4. Install new igniter into the chamber and tighten thumb
screw. Re-connect the wires to the 2 leads with the
spade connectors.
5.
Double check that the igniter wires are clear of any
movement, i.e. ash drawer, fire pot cleaning rod,
cleaning slide plates, etc.
6. Re-install the ash drawer and side panel and re-
connect the power.
Igniter
Igniter Bracket
Thumb Screw
Figure 29.1
CAUTION
Shock Risk.
•
Do NOT remove grounding prong from plug.
•
Plug directly into properly grounded 3
prong receptacle.
• Route cord away from appliance.
•
Do NOT route cord under or in front
of appliance.
Handle glass with Care.
•
Glass is 5mm thick high temperature heat-
resistant ceramic glass.
•
DO NOT REPLACE with any other material.
• Alternate material may shatter and
cause injury.
WARNING
