RR
R
November 2, 2005
7001-142C
Page 35
Santa Fe Pellet Stove
G. Glass Replacement
• Glass is 5mm thick high temperature heat-
resistant ceramic glass.
• DO NOT REPLACE with any other material.
• Alternate material may shatter and cause
injury.
WARNING
Figure 35.1
• Frequency:
As needed
• By:
Qualified Service Technician/Homeowner
• Task:
a. Open the face and remove door from the appliance
by lifting door off of hinge pin and lay on a flat
surface face down.
b. Using a screwdriver, tap the bottom of the rope
retainer rod to push it up out of the hole. The top
end of the rod will slide up. Swing the rod toward
you from the bottom and remove the rod. Repeat
for other side.
c. Remove old glass and replace with new glass.
d. Slide the retainer rod into the top hole first, and then
line up the bottom crimped end with the hole in the
door. The crimped end must be paralle with the
glass in order to insert it into place.
Figure 35.1.
F
.
High Ash Fuel Content Maint. (Cont’d)
Rope Retainer
Rods
Slide this end
in first
Crimped end at
the bottom
Crimped end
must be
parallel with
the glass
Glass
