6
05/22
8106-803B
B. Thermostat Wall Control Location
The thermostat wall control’s location will have some affect
on the appliance’s operation.
• If you need to run more than 25’ make sure you use a
continuous strand of 18 to 22 gauge thermostat wire.
• When located close to the appliance, it may require a
slightly higher temperature setting to keep the rest of the
house comfortable.
• When located in an adjacent room or on a different
floor level, you will notice higher temperatures near
the appliance.
C. Tools And Supplies Needed
Tools and building supplies normally required for installation,
unless installing into an existing masonry fireplace:
- Reciprocating Saw
- Channel Locks
- Hammer
- Phillips Screwdriver
- Tape Measure
- Plumb Line
- 1/4” Self-Tapping Screws
- Framing Material
- Hi-temp Caulking Material
- Gloves
- Safety Glasses
- Framing Square
- Electric Drill & Bits (1/4”)
- Level
May also need:
- Vent Support Straps
- Venting Paint
D. Inspect Appliance and Components
• Open the appliance and remove all the parts and articles
packed inside the Component Pack. Inspect all the parts
and glass for shipping damage.
• Report to your dealer any parts damaged in shipment.
• All labels have been removed from the glass door.
• Plated surfaces have been wiped clean with a soft cloth,
if applicable.
• Read all the instructions before starting the
installation. Follow these instructions carefully
during the installation to ensure maximum safety
and benefit.
• Follow pipe manufacturer instructions for installation
and air clearance requirements.
Risk of Fire!
• Damaged parts could impair safe
operation.
•
Do NOT install damaged, incomplete or
substitute components.
WARNING
WARNING
Hearth & Home Technologies disclaims any
responsibility for, and the warranty will be
voided by, the following actions:
• Installation and use of any damaged appliance.
• Modification of the appliance.
• Installation other than as instructed by Hearth & Home
Technologies.
• Installation and/or use of any component part not
approved by Hearth & Home Technologies.
• Operating appliance without fully assembling
all components.
• Operating appliance without legs attached (if supplied
with appliance).
• Do NOT Over fire!
Or any such action that may cause a fire hazard.
E. Removal of Appliance from Pallet
1. Remove box and 2x4 structural boards being careful not
to damage product
2. Using 3/8 socket or wrench, loosen the (2) retaining bolts
on the back of stove and remove right panel.
3. Using 7/16 socket or wrench, remove pallet mount bolts
and washers.
4. Remove pallet from under stove
5. Assemble side panel back on stove
Retaining Bolts
Pallet mount bolts and washers
Figure 6.1
