6
7036-187C
June 18, 2014
MT. VERNON AE INSERT
Emissions Rating:
EPA Compliance
*BTU Input:
14,620 - 60,200 / hr
Effi ciency:
Up to 86.5%
Heating Capacity:
Up to 3,000 square feet depending
on climate zone
Vent Size:
3” or 4” Type “L” or “PL”
Hopper Capacity:
56 lbs +/-5 lbs
Fuels:
Pellets, Shelled Field Corn, Wheat
and Black Sunfl ower Seeds
Shipping Weight:
425 lbs
*BTU will vary, depending on the type of fuel you use in your
appliance. Consult your Quadra-Fire dealer for best results.
C. Glass Specifi cations
This stove is equipped with 5mm ceramic glass. Replace
glass only with 5mm ceramic glass. Please contact your
dealer for replacement glass.
D. Electrical Rating
115 VAC, 60 Hz, Start 5 Amps, Run 1.25 Amps
Model
Mt. Vernon Pellet Insert AE
Laboratory
OMNI Test Laboratories, Inc.
Report No.
061-S-69-6
Type
Solid Fuel Room Heater/Pellet Type
Insert
Standard
ASTM E1509-04, ULC S628-93 and
ULC/ORD-C1482-M1990 Room Heater
Pellet Fuel Burning type and (UM)
84-HUD, Mobile Home Approved.
FCC
Complies with Part 15 of FCC Rules.
Operation is subject to the following
two conditions: (1) this device may not
cause harmful interference, and (2) this
device must accept any interference
received, including interference that may
cause undesired operation.
• Installation and use of any damaged appliance.
• Modifi cation of the appliance.
• Installation other than as instructed by Hearth & Home
Technologies.
• Installation and/or use of any component part not approved by
Hearth & Home Technologies.
• Operating appliance without fully assembling all components.
• Operating appliance without legs attached (if supplied with unit).
• Do NOT Overfi re - If appliance or chimney connector glows,
you are overfi ring.
Any such action that may cause a fi re hazard.
1
Listing and Code Approvals
A. Appliance Certifi cation
NOTE: Hearth & Home Technologies, manufacturer of
this appliance, reserves the right to alter its products, their
specifi cations and/or price without notice.
NOTICE:
This installation must conform with local codes. In
the absence of local codes you must comply with the
ASTM
E1509-04, ULC S628-93, (UM) 84-HUD and ULC/ORD-
C-1482-M1990.
Improper installation, adjustment, alteration, service or
maintenance can cause injury or property damage.
For assistance or additional information, consult a qualifi ed
installer, service agency or your dealer.
Quadra-Fire is a registered trademark of Hearth & Home
Technologies.
WARNING
Fire Risk.
Hearth & Home Technologies disclaims any
responsibility for, and the warranty will be voided by,
the following actions:
B. BTU & Effi ciency Specifi cations
E. Mobile Home Approved
•
This appliance is approved for mobile home installa-
tions when not installed in a sleeping room and when
an outside combustion air inlet is provided.
•
The structural integrity of the mobile home fl oor, ceil-
ing, and walls must be maintained.
•
The appliance must be properly grounded to the
frame of the mobile home and use only Listed pellet
vent Class “L” or “PL” connector pipe.
•
Outside Air Kit, part OAK-ACC must be installed in a
mobile home installation.
