Page
7014-139F
June 27, 2008
R
Figure 9
Vacuum out the exhaust area.
Loosen all 6 screws, but do NOT Remove
5.
Removing the Combustion (Exhaust) Blower
Figure 5
Figure 8
Figure 7 - Stove is shown in this example
Set blower on top of housing.
Do not disconnect the wires.
Figure 6
a. The combustion blower is mounted in the bottom
right rear of the appliance.
Figure 5.
b. Use an 11/2 nut driver to loosen all 6 nuts, but do
not remove. Rotate the blower and remove from
the housing.
Figure 6.
c. Set the blower on the top of the housing for the stove
and place on the firebox floor for the insert. You do
not need to disconnect the wires.
Figure 7.
d. Vacuum out the exhaust area.
Figure 8.
You
may need to replace the gasket at this time also.
Order part SRV7000-2.
e. A view of the inside of the exhaust area.
Figure 9.
BLOWER LOCATION ON STOVE
Combustion Blower
BLOWER LOCATION ON INSERT
Remove (6) Nuts
Remove
Side
Panel
Combustion Blower
