6
7082-151C
November 28, 2017
MT. VERNON E2 INSERT
-C
C. Quick Start Guide
January 8, 2016
QUICK START GUIDE
*Before you plug in this appliance, follow these instructions*
Ru
n
Set
U
p
Pr
im
e
1. Empty Fire box
2. Add pellets and close lid
3. Turn DIAL to OFF
4. Plug in the appliance
• Exhaust blower will run for about 45 Seconds (
wait for it to stop
before priming)
•
Green light will start fl ashing
5. Ensure thermostat is connected properly per included instructions.
1. After the exhaust blower has stopped; quickly turn the dial from OFF to HI
two times
• The LIGHT will turn solid green and pellets will feed. Wait for 2 minutes
• If the LIGHT did not turn solid green:
- Turn dial back to OFF
- Unplug appliance, plug it back in and repeat
Priming is only needed for fi rst fi re or starting fi re on empty hopper.
Note: The prime function is only required during initial set up of the unit,
or after the unit has alarmed out due to an empty hopper. Priming while
under normal operating conditions will cause the fi re pot to overfi ll.
HEAT
SETTING
HEAT
SETTING
O
FF
HI
LO
HEAT
SETTING
HEAT
SETTING
O
FF
HI
LO
HEAT
SETTING
HEAT
SETTING
O
FF
HI
LO
2. Choose Setting:
LO – HI*
Green LIGHT will be-
gin fl ashing and stove
will start
It may take as long as 10
minutes to achieve a fi re
in the fi re pot. Turning the
knob or thermostat to off
during this time will inter-
rupt the startup process.
*For fi rst fi re,
HHT recommends
running on HI for
fi rst 30 minutes
0
-1
-2
-3
-4
+1+2
+3
+4
ALARM
ON
HEAT
SETTING
HEAT
SETTING
O
FF
HI
LO
1. Press up arrow on thermo-
stat to desired temperature.
*
appliance will not turn on unless target
temperature is minimum of one degree
above room temperature.
Control Panel
Light
Dial
Trim