24
7095-803C
August 23, 2019
EXPEDITION II INSERT
F. Wiring Diagram
Blower
Snap Disc
Five Setting Switch
Switch
Power Cord
Figure 24.4
Figure 24.3
G. Door Handle
Service Part: SRV7063-014
1. Install washer on door handle shaft.
2.
Slide door handle through door.
3.
Install additional washer(s) as shown in
Figure 24.4
.
4.
Install key in groove.
5.
Align groove in latch cam with key; slide latch cam
over shaft
6.
Install locknut but do not over tighten, the handle needs
to move smoothly.
7.
Install handle turning in a counter-clockwise motion to
desired location on door handle rod
(Figure 24.4)
.
Locknut
Latch Cam
Spacing
Washers
Door Cross
Section
Square Key
Door Handle Shaft
Fiber Handle
E. Baffle Board
Service Part: SRV7095-117
1.
Remove all ash from the firebox, and extinguish all hot
embers before disposal into a metal container.
2.
It is easier to remove both baffle boards and ceramic
blanket after the tube channel assembly has been
partially disassembled and the right side lowered.
Follow steps 1 through 4 on page 25 for removal of
the tube channel assembly. It is not necessary to
completely remove the tube channel assembly.
3.
Once the baffle protection cover has been removed,
pull the baffle boards and ceramic blanket forward
about 1 inch (25mm) and then overlap the baffles about
1-2 inches (25-51mm)
(Figure 24.1)
.
4. Slide the tube channel assembly to the left as far as
it will go and lower the right side. Remove the baffle
boards and ceramic blanket together
(Figure 24.2)
.
5.
Re-install in reverse order. Be sure the baffle boards
and ceramic blanket are in their proper positions
(See
Figure 20.1 on page 20)
.
Figure 24.1
Figure 24.2
Baffle Boards Overlapping
Ceramic Blanket
The ceramic blanket and both baffle boards
and tube channel assembly can all be
removed at the same time.
CAUTION
DO NOT
over tighten lock nut. The door handle needs to
move smoothly.
Service Part: SRV7000-891
