4/12
433-1390K
Page 15
Final stage:
The final stage of burning is the charcoal stage. This occurs
when the flammable gases have been mostly burned and
only charcoal remains. This is a naturally clean portion of
the burn. The coals burn with hot blue flames.
It is very important to reload your fireplace while enough
lively hot coals remain in order to provide the amount of heat
needed to dry and rekindle the next load of wood. It is best
to open the air control for a short while
before reloading
.
This livens up the coalbed. Open door slowly so that ash or
smoke does not exit fireplace through opening. You should
also break up any large chunks and distribute the coals so
that the new wood is laid evenly on hot coals.
Fireplace operation does require air. Do not take air from
other fuel burning appliances which can result in improper
venting (smoking) or air dilution. Always provide adequate
makeup air.
2nd stage:
The next stage of burning, the secondary stage, is the period
when the wood gives off flammable gases which burn above
the fuel with bright flames. During this stage of burning it is
very important that the flames be maintained and not allowed
to go out. This will ensure the cleanest possible fire. If you
are adjusting your fireplace for a low burn rate, you should
close down the air to the point where you can still maintain
some flame. If the flames tend to go out, the fireplace is set
too low for your burning conditions.
Left - Close
Right - Open
Low
Setting
Meet
Resistance
Move past
3/4" to High
High
Setting
IMPORTANT!
As you move the Combustion Air Control
to the RIGHT, you will feel resistance about three-fourths
of the way. You must move past that resistance approxi-
mately 3/4 in. (19mm) to fully engage the Automatic
Combustion Control (ACC) sytstem.
With the Automatic Combustion Control system that is on this
fireplace, you can set the fireplace to high (slide the Combus-
tion Air Control all the way to the right), start the fire, and then
move the Combustion Air Control to the desired burn level.
The fireplace will automatically go to that level once the fire
is fully established. This allows for less interaction with the
fire by the homeowner and more efficient use of fuel while
maintaining the desired heat output.
After the fireplace has been in operation for a period of time,
and is warmed up; you may prefer to not activate the ACC
when reloading fuel. if you do not slide the Combustion Air
Control all the way to the right, the ACC will not be activated.
The lever located to the right of the Combustion Air Control
is the ACC OVERRIDE and may be used to override the
setting of the Combustion Air Control. If the ACC has been
activated and burn rate needs to be slowed, move the
lever to the LEFT and position Combustion Air Control at
the preferred setting. To close the air supply for an over
fire situatution or to slow the burn rate down immediately,
slide the lever to the LEFT and also slide the Combustion
Air Control all the way to the left.
NOTICE
:
If reloading a bright, hot coal bed for longer (low)
burn time, setting the ACC may not be required. Burn Dry,
well seasoned wood.
NOTICE
:
To establish your settings, always begin with the
air control all the way to the left to STOP and then move it
to the right for your desired setting.
*Slide Air Control
Slide LEFT to Stop
Stop to 1/8 in. -1/2 in. open
Stop to 1/2 in. - 1-1/2 in. open
All the way to RIGHT
THE DECORATIVE FAsCIA mUsT bE REmOVAblE ON
YOUR FIREplACE IN ORDER TO sERVICE THE AUTO-
mATIC COmbUsTION CONTROl sYsTEm.
Notice
:
Figure 2.5 Operating the ACC Controls
O. Automatic Combustion Control (ACC)
P. ACC Override
